Program remotes GM trucks 07 and up

Program remotes GM trucks 07 and up

Switch ignition ON.

Repeatedly press vehicle information button (it is usually located on the right or left from the steering column depending on year make and model) until PRESS TO RELEARN remote is displayed.

Press set/reset button until remote key LEARNING ACTIVE is displayed.

Programming mode activated, proceed as follows:

Press and hold lock and unlock buttons on first remote simultaneously for 15 seconds.

Wait for sound signal indicates correct programming.

Repeat above procedure to program remaining remotes.

Switch ignition OFF to exit programming mode.

Remotes can also be programmed using diagnostic equipment.

A maximum of 8 remotes can be programmed.

Download Remote Instructions

 

These programming instructions work for the following vehicles.

Some vehicles may require locksmith or computer programming

2008 2009 2010 Buick Enclave keyless entry remotes

2006 2007 2008 2009 2010 Buick Lucerne keyless entry remote

2007 2008 2009 2010 Cadillac Escalade keyless entry remote controls

2007 2008 2009 2010 Chevy Avalanche keyless remotes

2007 2008 2009 2010 Chevrolet Equinox remote control transmitters

2007 2008 2009 2010 Chevrolet Monte Carlo transmitter controls

2006 and up Chevy Impala remote door transmitters

2007 2008 2009 2010 Chevy Silverado truck remote control

2007 2008 2009 2010 Chevrolet Suburban remotes

2007 2008 2009 2010 Chevy Tahoe keyless entry remotes

2007 2008 2009 2010 Chevrolet Traverse keyless entry remote

2007 2008 2009 2010 GMC Acadia remote controls

2007 2008 2009 2010 GMC Sierra truck remote door openers and remote start

2007 2008 2009 2010 GMC Yukon remote with and without remote engine start

2008 2009 Hummer H2 keyless entry remotes

2007 2009 Pontiac Torrent remote entry system control